Hand bending 1-3/4 inch 14 gauge square steel tube

Posted on April 1, 2010 by admin

This is just about the limit of my strength, unless I use a bigger cheater bar. And this is one case in which having a little greater, um, physical inertia comes in handy.

For more info on hand bending, see http://www.metalgeek.com/bend

Duration : 0:2:4


[youtube VO-OatK4HzI]

This entry was posted in square tubing and tagged , , , , , . Bookmark the permalink.

One Response to Hand bending 1-3/4 inch 14 gauge square steel tube

  1. artgoat says:
    April 1, 2010 at 4:22 pm

    Nice! Is that “72″ …
    Nice! Is that “72″ on the guide the radius of the bend? I had a job that needed a 72″ diameter, once in 14ga 1.75 square, and I wasn’t sure how to do it.